Correct print settings for colorFabb nGen

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Allan Sche Sar
Posts: 7
Joined: Fri Aug 11, 2017 10:56 am

Correct print settings for colorFabb nGen

Postby Allan Sche Sar » Sun Dec 17, 2017 9:43 am

Hello everyone,

I want to print with colorFabb nGen because the properties (heat resist, easy to print, robust) sound good for me.
But I don't have good results.
The print quality looks very good without stringing. But the parts are not strong. The parts are very brittle.
I change my print settings especial the manual fan slider. Also I tested different part orientations - no strong impact.

These are my print settings:
  • print temp: 235 °C
  • Bedtemp: 70-85 °C (no different results)
  • resolution: 0,1 mm
  • print speed.: 40-50 mm/s
  • fan opening: 0 to 100 %

Somebody print colorFabb nGen on his Raise3D N1 and can tell me the settings?
Attachments
IMG_20171214_205234037.jpg

User avatar
Michael.P@Raise3D
Posts: 200
Joined: Wed Jul 20, 2016 4:51 pm
Location: Costa Mesa
Contact:

Re: Correct print settings for colorFabb nGen

Postby Michael.P@Raise3D » Fri Dec 22, 2017 9:21 pm

Hi Allan Sche Sar,

You may want to try a different orientation on the model, the print is more prone to breakage when standing up like it is. The part broke on the seam line, so increasing temp may help as well.
Michael Petitclerc, Technician
Tel: +888 963 9028
Web: http://www.raise3d.com

Allan Sche Sar
Posts: 7
Joined: Fri Aug 11, 2017 10:56 am

Re: Correct print settings for colorFabb nGen

Postby Allan Sche Sar » Sat Dec 23, 2017 2:16 pm

I printed the model in different orientations and there is no different. The cracked area is not every time the same point.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 3 guests