Raise3 ABS Permium does not stick to build plate

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Tinkerer
Posts: 176
Joined: Mon Oct 09, 2017 8:30 pm
Location: Germany

Raise3 ABS Permium does not stick to build plate

Postby Tinkerer » Thu Dec 07, 2017 11:18 am

Hi there,

I was able to print small (20x20x10mm) test cubes using the R3D ABS Premium.
But even with them I encountered some edge warping already:
IMG_4007.jpg


Now I've tried to print something bigger but had to recognize the material does not stick to the build plate at all.

I have tried so far:
Nozzle temp. from 230 - 245°C; build plate temp. from 80-100°C.
Z-Gap adjusted to 0,15mm, build plate leveling checked to be okay.

Build plate setups I tried so far:
1 buildtak w.o. any coating
2 buildtak w. hairspray coating
3 buildtak w. Paper-Glue-Stick (Pritt)
4 3 on top of 2
5 glas with Paper-Glue-Stick

The prints always fail already during the print of the raft.

Do you guys have any tips how I can successfully print with the Raise3D ABS Premium?
Since the small parts I did print so far really look much better than with the other ABS I have available.
That other ABS by the way sticks to the buildtak surface like hell, even w.o. any additional coating.

Thanks in advance & have a nice day;-)
...there's nothing like the smell of fresh ABS in the morning...

User avatar
Michael.P@Raise3D
Posts: 225
Joined: Wed Jul 20, 2016 4:51 pm
Location: Costa Mesa
Contact:

Re: Raise3 ABS Permium does not stick to build plate

Postby Michael.P@Raise3D » Thu Dec 07, 2017 7:06 pm

Hi Tinkerer,

For the Raise ABS I normally run on the Glass with Purple Glue sticks. My settings are:
Nozzle: 245c
Bed: 110c
Z-Gap at .2 (the shim I have on hand)

I preheat the printer with the build plate for about 15 minutes before a print job. Did you happen to just modify the PLA profile for temp or did you use the ABS setting?
Michael Petitclerc, Technician
Tel: +888 963 9028
Web: http://www.raise3d.com

Tinkerer
Posts: 176
Joined: Mon Oct 09, 2017 8:30 pm
Location: Germany

Re: Raise3 ABS Permium does not stick to build plate

Postby Tinkerer » Thu Dec 07, 2017 7:12 pm

Hi Michael,

thanks for the info.

What is this purple glue stick? Is that "Elmers Glue stick"?

I do have "Uhu" and "Pritt" Glue Stick at hand while the later seems to work better for most materials.
...there's nothing like the smell of fresh ABS in the morning...


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 1 guest