Less filament extruding

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
benny32
Posts: 20
Joined: Tue Jun 21, 2016 2:42 am

Less filament extruding

Postby benny32 » Wed Dec 06, 2017 1:15 pm

I recently bought and installed the DualDirect upgrade kit from Bondtech for my N2+ and installed a .40 ruby nozzle. Now when I try to print anything it seems like I am getting a fair bit less filament extruded out and of course things are working. I am using standard 1.75 pla but it's such a small amount that it doesn't seem to even stick to the build plate, it just gets pulled around. I ordered some new build plate material since mine is a little raged looking but I don't really think that's my problem. Anyone have any ideas? I'm using stock Normal PLA settings in ideamaker for reference.

benny32
Posts: 20
Joined: Tue Jun 21, 2016 2:42 am

Re: Less filament extruding

Postby benny32 » Wed Dec 06, 2017 1:48 pm

Think I found my own answer. If others have the same issue the solution is in this thread. Running a test print now but early results look good.

viewtopic.php?f=4&t=3919


Return to “Printing Settings”

Who is online

Users browsing this forum: zemlin and 3 guests