My profile share for PLA

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Tacblades
Posts: 25
Joined: Sun Oct 29, 2017 9:23 pm

My profile share for PLA

Postby Tacblades » Thu Nov 02, 2017 10:11 am

I have profiles for each filament i use and calibrate them for all areas like bridging, retraction, supports, fills and speed.

Here is one of my PLA profiles if its of interest as a basis to start from.

https://goo.gl/b4jmKG
Last edited by Tacblades on Thu Nov 02, 2017 12:47 pm, edited 1 time in total.

User avatar
Vicky@Raise3D
Posts: 2580
Joined: Fri Mar 25, 2016 3:54 am

Re: My profule share for PLA

Postby Vicky@Raise3D » Thu Nov 02, 2017 10:39 am

Thanks for your kindly sharing!
These profiles are tested with your modified machine right?

Tacblades
Posts: 25
Joined: Sun Oct 29, 2017 9:23 pm

Re: My profule share for PLA

Postby Tacblades » Thu Nov 02, 2017 12:08 pm

Vicky@Raise3D wrote:Thanks for your kindly sharing!
These profiles are tested with your modified machine right?


Yes on a creality cr-10s running marlin 1.1.6 firmwear

bigrizz
Posts: 1
Joined: Thu Nov 30, 2017 6:15 am

Re: My profile share for PLA

Postby bigrizz » Thu Nov 30, 2017 6:19 am

Hi Tacblades. Tried downloading your profile but it says it was deleted. Did you pull the PLA profile off Dropbox? I was keen to try it.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests