X-Y-Z adjustment

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
charles@linquist.net
Posts: 16
Joined: Fri May 27, 2016 11:45 pm

X-Y-Z adjustment

Postby charles@linquist.net » Fri Aug 25, 2017 5:48 pm

My N2 can't print a 300mm X 300mm print as advertised because it prints too far "forward" and too far to the left. I went into SETTINGS on the control panel and changed the "X" and "Y" values, but those don't seem to "stick" when I leave that screen and start a print.

How do I permanently change the X, Y and Z references in the printer? I would rather do it in the printer rather than in any slicing software.

User avatar
Brandon
Posts: 62
Joined: Fri May 05, 2017 1:22 pm

Re: X-Y-Z adjustment

Postby Brandon » Fri Aug 25, 2017 7:45 pm

This is currently only handled in the software. You need to change in the profile and save the profile. You would either clone that profile or if you are switch to other material profiles make changes to these settings in that profile and save it.

Advanced - Other.JPG


Return to “Printing Settings”

Who is online

Users browsing this forum: Baidu [Spider] and 2 guests