New Printer Question

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 1
Joined: Tue Mar 07, 2017 5:12 pm

New Printer Question

Postby Robcare » Tue Mar 07, 2017 5:24 pm

Hello all,

Just got new printer and learning all I can. When I set the temp of the Left Nozzle to 275 on advanced settings, the nozzle heats up to 265 and then just stops there. If I set it to 265, it heats up to 255 and stops...Am I missing somthing? It wont start a print without getting within a degree or two of set temp. Please advise.


Posts: 2487
Joined: Tue Mar 22, 2016 1:40 am
Location: In a van, down by the river

Re: New Printer Question

Postby Jetguy » Tue Mar 07, 2017 6:57 pm

You probably should read this thread on the same problem viewtopic.php?f=4&t=1505&p=13015#p13015

User avatar
Posts: 3618
Joined: Fri Mar 25, 2016 3:54 am

Re: New Printer Question

Postby Vicky@Raise3D » Fri Mar 10, 2017 8:43 am

Is that your printer is a single-nozzle printer or dual-nozzle printer?
Does it also has problem at low temperature?

Posts: 4
Joined: Fri May 19, 2017 4:29 am

Re: New Printer Question

Postby MariaJones » Mon May 22, 2017 7:28 am

Just search on Google, you will find a lot of answers related to this. There are many reasons due to which printer does not print properly. The best solution is to read the material & specification sheets.

Return to “Printing Settings”

Who is online

Users browsing this forum: Bing [Bot] and 2 guests