Just got new printer and learning all I can. When I set the temp of the Left Nozzle to 275 on advanced settings, the nozzle heats up to 265 and then just stops there. If I set it to 265, it heats up to 255 and stops...Am I missing somthing? It wont start a print without getting within a degree or two of set temp. Please advise.
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests