Ideamaker 0.6mm nozzle settings?

[mojoab]

Does anyone have Ideamaker print settings for a 0.6 mm nozzle for PLA? I've changed the nozzle diameter size in print setting and bumped the temp up a bit. I'd like to change the Pro2 plus over to 0.6 mm nozzles. Thanks

[Vicky@Raise3D]

You may need to increase the flowrate for filament and also the retraction settings may need to be tuned based on your result.
And don't use Raft for nozzle not with 0.4mm size. The current configurations for Raft in ideaMaker are tuned based on 0.4mm nozzle.

[crimsonyoshi]

You may also need to increase your layer size a bit (from 0.2 to 0.25 or 0.3). If you don't get a quick enough answer on the forums, you can always give tech support a call. They have a bunch of numbers for all of the different nozzles.

[mojoab]

Thanks everyone!

[JeffS]

Hi Vicky,
Is it possible to include proper raft settings for all nozzle sizes in next IdeaMaker version? Maybe not so much for the 3D printing purists, but for the general user, it is sometimes the fastest way to get a print to stick and complete. Thanks.

[Vicky@Raise3D]

Hi Vicky,
Is it possible to include proper raft settings for all nozzle sizes in next IdeaMaker version? Maybe not so much for the 3D printing purists, but for the general user, it is sometimes the fastest way to get a print to stick and complete. Thanks.

Thanks for your suggestion!
We have put different nozzle print default profile test into our developing list. We will try to achieve the final result in near future.

[JeffS]

Sounds good. Thanks Vicky.