Right extruder slice appears to invert model?

[red]

Hey folks, I have recently procured a Pro2 and was hoping someone could suggest why this is happening.

I slice with right-click "left extruder" selected and the slicer preview shows it good to go. When I slice with the "right extruder" the previewed mesh seems to have inverted and then desperately tied to close the surface, giving me a mess.

This is sliced using Standard Pro2 PLA, with the Right Extruder enabled in the Advanced settings.

Am I missing step? Thanks!

[Vicky@Raise3D]

You need to go to the tab including Raft settings in Advanced Settings to set Raft Nozzle to be right nozzle.

[Noren]

I think that's the Wipe Wall you are seeing.

[red]

Hey, thank you for the replies. Unfortunately, I'm still have an issue.

When I set the raft to the right extruder I still get a bad mesh:

When I select everything to print via the right extruder I get this:

[red]

I think that's the Wipe Wall you are seeing.

Thank you Noren, I believe you are exactly right! I had not used the layers slider within the preview and hadn't seen that the underlying mesh was just fine. I am new to FFF and wasn't aware of wipe walls. Thank you again.

[Vicky@Raise3D]

Hey, thank you for the replies. Unfortunately, I'm still have an issue.

When I set the raft to the right extruder I still get a bad mesh:

rightRaftLeftSupports.JPG

When I select everything to print via the right extruder I get this:

allRightExtruder.JPG

Looks that the support generated is printed by left nozzle. You need to change the support nozzle to right as Raft nozzle.