Hello, we've recently been having troubles with both our Pro2 and N2 Plus printers with their printing temperatures. Whenever we set something to print on the machines, the temperatures reset. On the N2 Plus, the Heatbed resets to 40°. On the Pro2, both extruders reset to 205° and the Heatbed resets to 40°. We've never altered the temperatures in the 'Tune' section.
We've found a temporary solution in setting the temps after it's done with the temperature setting and calibration. However we're looking for a permanent fix. Any help is appreciated, thank you.
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests