Print Settings for Raise3D PC and PETG

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
zpennington
Posts: 2
Joined: Tue Nov 06, 2018 1:48 pm

Print Settings for Raise3D PC and PETG

Postby zpennington » Tue Nov 06, 2018 1:54 pm

Hello,

Does anyone have the recommended settings for the new PC and PETG material that Raise is offering? I have printed with these material already on our Pro2 with IdeaMaker but I would like to run their IdeaMaker settings. I looked on the tech data sheet and it says that the settings were used with Simplify 3D and not IdeaMaker...

User avatar
Vicky@Raise3D
Posts: 4418
Joined: Fri Mar 25, 2016 3:54 am

Re: Print Settings for Raise3D PC and PETG

Postby Vicky@Raise3D » Tue Nov 06, 2018 11:16 pm

The PC and PETG profiles under Pro2 series printers in newly released ideaMaker 3.3.0 should can work properly with these two filament.

zpennington
Posts: 2
Joined: Tue Nov 06, 2018 1:48 pm

Re: Print Settings for Raise3D PC and PETG

Postby zpennington » Wed Nov 07, 2018 12:31 pm

Thanks for the information. I will have to re-download those profiles again since I tweaked them to print the other companies materials.

User avatar
Vicky@Raise3D
Posts: 4418
Joined: Fri Mar 25, 2016 3:54 am

Re: Print Settings for Raise3D PC and PETG

Postby Vicky@Raise3D » Wed Nov 07, 2018 11:57 pm

Install the latest version and restore the profiles to be default settings.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 1 guest