Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
2 posts • Page 1 of 1
Hello, I'm trying to resolve some stringing and poor surface quality under supports with PLA fanspeed is set at 100. It looks like it is under-extruding, but I'm assuming that is because it doesn't have a surface to squish the filament against. The top side of the print looks beautiful. Printed using s3d. Any help would be great!^top side of prop underside of prop s3d print preview s3d settings
I have the same issue with overhand. It seems like the last layer of support is stuck to the part making it look nasty. They are hard to remove also. Most of the time, I'll just keep them there if the dimensions are not critical.
Who is online
Users browsing this forum: No registered users and 3 guests