What settings do I need to set to stop all the stringing from PET-G and PVA as a support with it so material only comes out of the nozzles when its supposed to.
Also in general what kinds of settings for both should I set for Speed, Standard and HQ so nothgin getting cooked, or problems but fast as possible?
I have a N2 Dual V2 with Bondtech dual extruders and silicon shoes on the hot ends
What settings do I need to set to stop all the stringing from PET-G and PVA as a support with it so material only comes
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests