I recently bought a Pro2 Plus and have been seeing some issues with my prints. Below is a picture of the defect I've seen while printing with ABS and PLA.
At first I thought it was a temperature issue. I saw that my left extruder temperature was varying from 246-253C, so I re-tuned the PID. That didn't help so I contacted Raise3d and they sent me a new thermocouple, which I haven't installed yet. Since then I switched to printing with the stable right extruder. I've seen the same issue while trying to eliminate it with temperature, retraction, and a negative value for extra on restart. Below are my current settings.
I printed a small calibration part with the same wall thickness that didn't show this defect with these settings. Does anyone have advice on this?
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests