I'm seeing a really stringy first layer being layed down overtop some support needed to support an overhang.
I don't recall seeing this on other parts I've printed where there was "ledge" or "shelf" of support material supporting a significant overhang.
What do you guys think ?
This is with PETG being fed from a PrintDry.
0.2mm layer height.
245C nozzle temp.
20% part infill
20% infill for support , using Lines as the support method.
vertical offset top layers: 1
vertical offset down layers: 1
40 mm/sec all around speeds.
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests