What settings are you using to print at 0.1 or 0.05mm?
I can't seem to manage to successfully print with these settings.
Any luck printing @ 0.1mm / 0.05mm layer thickness?
-
- Posts: 14
- Joined: Sun Dec 18, 2016 8:48 pm
Re: Any luck printing @ 0.1mm / 0.05mm layer thickness?
material speed nozzle size ??? .05 i havent been succesful but i mean...all i had to do is run the max quality pla settings and done...it prints .1....
Re: Any luck printing @ 0.1mm / 0.05mm layer thickness?
eagle1xray wrote:material speed nozzle size ??? .05 i havent been succesful but i mean...all i had to do is run the max quality pla settings and done...it prints .1....
What did you use for slicing? I use Simplify3D here.
Re: Any luck printing @ 0.1mm / 0.05mm layer thickness?
I only briefly tried printing with S3D on my Raise3D. But I had a hard time getting any good results. And I think that the results on the Raise3D machines with IdeaMaker is on par or better than S3D.
I have also successfully printed .1 and .05 with the default High Quality templates.
Correct distance from nozzle to bed is important.
And use a raft.
What are the problems that you have?
I have also successfully printed .1 and .05 with the default High Quality templates.
Correct distance from nozzle to bed is important.
And use a raft.
What are the problems that you have?
Who is online
Users browsing this forum: No registered users and 4 guests