Print failed at very end

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Snalios
Posts: 17
Joined: Thu Aug 09, 2018 1:39 pm

Print failed at very end

Postby Snalios » Wed Aug 22, 2018 12:03 pm

Came into work this morning to a failed print right at the end. I looks like it tried to print the area that failed, but it just dragged the nozzle over it. No layer shifts that I can tell. Could it have anything to do with the dense support layer I have on?

20180822_075711.jpg
20180822_075714.jpg
20180822_075723.jpg

Snalios
Posts: 17
Joined: Thu Aug 09, 2018 1:39 pm

Re: Print failed at very end

Postby Snalios » Wed Aug 22, 2018 12:27 pm

Print may have also came loose from the build plate. It was not at the center of the plate when I came in.

Am I getting proper raft squish?
20180822_081739.jpg


I did notice that right before it starts extruding the raft, the build plate drops slightly from the Z-offset I set at the start. I don't see any signs of warping on the raft.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 6 guests