Print settings for 3DXTech PC/ASA

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
jmenking
Posts: 2
Joined: Tue Sep 05, 2017 12:22 pm

Print settings for 3DXTech PC/ASA

Postby jmenking » Wed Sep 13, 2017 2:34 pm

Hello,

I am beginning some test prints using 3DXTech PC/ASA filament. I will post results when I'm done, but has anyone tried a PC or PC alloy before?

User avatar
Mecha_Monster
Posts: 126
Joined: Wed May 11, 2016 2:07 am
Location: Mexico
Contact:

Re: Print settings for 3DXTech PC/ASA

Postby Mecha_Monster » Thu Sep 14, 2017 2:43 am

Not that brand, but I had print a lot of things with Polymaker's PC-Max. It sticks fairly well to the Buildtak, but you have to set it to 110 and let it heat for at least 40 min. I print slow, no raft, but with a 10 lines brim, 270 degrees. Slow, less than 40 mm/s.
Also, procure to remove the printed part when the buildplate is still hot, if you let it cool down you will have a hard time removing it.
By the way, PC supports comes off very cleanly, be generous with the support if you need it.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests