Page 1 of 1

Cuttin it close... real close.

Posted: Tue May 15, 2018 2:50 am
by mb300sd
Just finished a print with this much filament left...

P_20180514_224603.jpg


Just barely above the extruder gear.
Ideamaker's estimate is pretty dead on, 21.4g estimated, and I weighed the spool at 23.x, minus whatever was wasted loading filament and purging at the beginning at the print. :D

Re: Cuttin it close... real close.

Posted: Tue May 15, 2018 4:58 am
by Vice Chief
Wow. Do I recognize that red filament?

Re: Cuttin it close... real close.

Posted: Tue May 15, 2018 11:07 pm
by mb300sd
Vice Chief wrote:Wow. Do I recognize that red filament?


Yep, that was the last bit of it, thanks :) Tided me over until they restocked and the order arrived, today actually.