My N2 + with Bondtech runs without breakdowns for months. But recently, on prints of 48h, it disconnects after 5h (the printhead goes anywhere, the plate goes suddenly down to the height of the finished piece) and I get the message: "Error map: Error: checksum mismatch, Last line ... "(photos).
If I try to restart the print I gent an other error message (in french): Nous avons rencontré une erreur serie pendant la derniere impression" (photo)
I'm talking about Gcode I already printed before.
For shorter prints, it goes very well (one or two hours).
Thank you for your answers
Any topics that don't fall into above categories. Please note that your thread may be moved to other discussion boards.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests