Bed Level Flattness looks not flatt - Is it normal?

Any topics that don't fall into above categories. Please note that your thread may be moved to other discussion boards.
chrons
Posts: 11
Joined: Sat Jun 17, 2017 4:50 pm

Bed Level Flattness looks not flatt - Is it normal?

Postby chrons » Thu Aug 17, 2017 2:22 am

Last project I made long and widht object with brim

"thx to jet guy who suggest using brim"

Now I make another long and width object with brim and I realize at some part of bed, there are thick brim and thin brim which I assume the bed not entirely flat. (see picture)

is this normal?

has anyone similar bed flatness in their N2?
Attachments
IMG_0502.JPG

User avatar
Vicky@Raise3D
Posts: 2440
Joined: Fri Mar 25, 2016 3:54 am

Re: Bed Level Flattness looks not flatt - Is it normal?

Postby Vicky@Raise3D » Thu Aug 17, 2017 9:18 am

Would recommend you to carry out a bed leveling.
Here is the instruction: http://www.raise3d.com/pages/bed-leveling-instruction
Please check the whole bed before start. If only one section like the picture above, then only need to adjust that adjusting point under.

socke
Posts: 220
Joined: Mon Mar 21, 2016 2:55 pm

Re: Bed Level Flattness looks not flatt - Is it normal?

Postby socke » Thu Aug 17, 2017 1:18 pm

chrons wrote:is this normal?

has anyone similar bed flatness in their N2?


This shouldn't be normal, but many of us have had the same trouble.
There are already a lot of threads in this forum, also some mods.
Here is my own solution: http://forum.raise3d.com/viewtopic.php?f=4&t=1590


Return to “Others”

Who is online

Users browsing this forum: No registered users and 1 guest