Page 1 of 1

Variable extrusion width.

Posted: Sat Dec 09, 2017 2:16 pm
by ABH
I like ideaMaker very much as a slicer, but I still mostly use Simplify3D, because Simplify3D keeps adding new and extremely good features that ideaMaker (still) doesn't offer.

In Simplify3d 4.0 we got variable extrusion width, called "single extrusion walls" and "single extrusion fill".
These features are very nice and I use them a lot for precise printing of narrow structures. It basically removes the earlier constraint that thin walls optimally should be multiples of the extrusion width, i.e. 0.4, 0.8, 1.2 mm etc.

So, this is a request for adding variable extrusion width to ideaMaker.

Re: Variable extrusion width.

Posted: Mon Dec 11, 2017 8:52 am
by Vicky@Raise3D
Have taken a look already. It's a cool feature. We will take it into consideration. Thanks for your suggestion.