I like ideaMaker very much as a slicer, but I still mostly use Simplify3D, because Simplify3D keeps adding new and extremely good features that ideaMaker (still) doesn't offer.
In Simplify3d 4.0 we got variable extrusion width, called "single extrusion walls" and "single extrusion fill".
These features are very nice and I use them a lot for precise printing of narrow structures. It basically removes the earlier constraint that thin walls optimally should be multiples of the extrusion width, i.e. 0.4, 0.8, 1.2 mm etc.
So, this is a request for adding variable extrusion width to ideaMaker.
Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest