I have just read about a new setting for Cura, Ironing. The function runs the hot nozzle over the top layer without extruding plastic (or maybe just a little bit, about 10%) to iron the crests and fill the gaps, smoothing the surface. Not sure if that's a feature or a hack, but the results looks great. Would it be possible to look into it and evaluate its fact-ability for Ideamaker?
Picture: Normal Top Layer vs Curas Ironing
Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 3 guests