I normally use windblows but was I having problems yesterday and needed to use Macs - but the printer wouldn't read the usb stick!
It turns out that the printer can't read the default format of Ios. May I suggest that you put a warning to that effect on the download page i.e. devices must be formatted FAT32 to be read by the printer
Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests