auto-height (not auto-level)

Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
AJM
Posts: 7
Joined: Tue May 02, 2017 11:20 pm

auto-height (not auto-level)

Postby AJM » Wed May 17, 2017 11:30 pm

I use various print surface, so the height has to be adjusted every time.
It would be good if the Z-stop switch is moved to above the actual print surface so that it automatically adjusts for the difference in plate thickness. Right now, it measures Z-height of the bottom of the plate which does not take the actual surface thickness into account. That would be OK for printers with non-removable bed surface, but not for Raise3D.

Moving the switch would be a relatively easy hardware change and it can be retrofit.
Auto-level would solve the problem as well, but it is not necessary for a rigidly-built printer.

User avatar
Michael.P@Raise3D
Posts: 34
Joined: Wed Jul 20, 2016 4:51 pm
Location: Costa Mesa
Contact:

Re: auto-height (not auto-level)

Postby Michael.P@Raise3D » Wed Jun 21, 2017 12:46 am

Placing the Z-Endstop on the build plate would be a more of a task than just "getting it done". The build plate is being measured from the bottom of the plate but it is offset from the Z-Screw. In order to adjust automatically we would need to place a Z-Sensor onto the print head as the sensor would need to contact the bed before the nozzle. At that point we might as well have an auto level system. The only problem with that is when you implement more electronics and more software you could get more problems. I own a number of printers including the Zortrax M200, It has a Z-Height detection system. It has plowed into the bed 5 times over two years, each time damaging the perforated plate, buildtak, and nozzle. The cause of which was just software error, and one time part failure.

If you mean to move the Z sensor closer to the build plate and have it physically touch the bed plate them we could do that. The one thing to remember is that the build volume on our machines starts at the home position (technically off the bed plate by a few mm) then placing the sensor on the front or left side could impede the path of printing or homing.

Just my thoughts on the matter.
Michael Petitclerc, Technician
Tel: +888 963 9028
Web: http://www.raise3d.com


Return to “Feature requests, ideas, wishes”

Who is online

Users browsing this forum: No registered users and 1 guest