IdeaMaker field sequences

Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
User avatar
JohnSays
Posts: 638
Joined: Tue Apr 26, 2016 2:42 pm
Location: Saint Petersburg, FL

IdeaMaker field sequences

Postby JohnSays » Tue May 09, 2017 2:11 pm

The programmers need to go through IdeaMaker and make the fields follow one another correctly when the tab key is pressed. Right now fields are not in a recognizable or predictable order.
Last edited by JohnSays on Tue May 09, 2017 5:08 pm, edited 1 time in total.
- John
2 Raise3D N2 Duals, V2 nozzles, Bondtech BMGs, adjustable table, Panucatt SD2224 drivers, run-out sensor, thermal overload protection resistors on motion controller board, Firmware 1.1.8ABH - with Lin_Advance, Palette+

User avatar
walshlg
Posts: 1349
Joined: Wed Mar 23, 2016 12:01 pm

Re: IdeaMaker field sequences

Postby walshlg » Tue May 09, 2017 4:22 pm

yes!!

User avatar
Vicky@Raise3D
Posts: 4564
Joined: Fri Mar 25, 2016 3:54 am

Re: IdeaMaker field sequences

Postby Vicky@Raise3D » Thu May 11, 2017 6:57 am

Notes taken.


Return to “Feature requests, ideas, wishes”

Who is online

Users browsing this forum: No registered users and 2 guests