Page 1 of 1

Feature Request: Inner/Outer Shell Extruder

Posted: Wed Nov 07, 2018 8:37 pm
by nlkulick
It would be awesome if there was a way to select different extruders for the inner and outer shells in Ideamaker. I believe Cura already has this feature. But this would be especially useful for the purpose of printing a part with less expensive inner material and a shell of more expensive, better looking outer material. This is important for making large quantity prints more cost effective.

Thanks for the consideration!

Re: Feature Request: Inner/Outer Shell Extruder

Posted: Thu Nov 08, 2018 11:39 pm
by Vicky@Raise3D
Noted. Will add it into requesting list.

Re: Feature Request: Inner/Outer Shell Extruder

Posted: Fri Nov 09, 2018 9:07 am
by Shelton
The question is how this work in the real world... because we have two different materials to bond together.