This is the "Gunstar" spaceship from the movie "The Last Starfighter", found on Thingiverse as https://www.thingiverse.com/thing:14639
I printed it out this weekend as a gift for a friend who is a big fan of that and other SF movies from the '80s & '90s.
There's going to be a good bit of post-processing to do. I need to glue the two halves together, sand-and-fill around the edges, then either paint or give an XTC-3D coat.
I think it turned out pretty good.
It took about 26 hours total to print as 2 halves, at 15% infill and a 0.2mm layer-height in Hatchbox silver PLA.
I printed it with a single extruder because the whole support structure was just a couple thin pillars to support the cockpit at the top and a couple other small features. It didn't seem worth the extra time and material required to use PolySupport and a wipe-wall or tower.
At some point when I have a couple spools of silver or grey and a week to spend on watching it, I might print myself one at max-size.
I'll post more as I make progress finishing it.
Show off your prints, mods, etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests