Page 1 of 1

First 3d printer. First Prints.

Posted: Wed Jan 31, 2018 4:32 pm
by Timber Haint
These pictures do no justice to the actual prints. The lighting is poor in some and in others the flash highlights things not normally seen.

All of these are using the Standard V2 Hotend PLA setting. Changes to this setting are noted in ().

Any and all questions welcome.

Hatchbox PLA - (3 shells, 20% infill, no raft)

Image

Image

Hatchbox PLA - Standard V2 Hotend Setting (3 shells, 20% infill, raft)

Image

Image

Image

Raise3d Premium PLA - (3 shells, 20% infill, no raft)
Very first print. Came out great.

Image

Image

The overhangs on this PLA are a little "stair-steppy" and rough. Sorry R3D, I think the Hatchbox works a little better as shown in green above.
Image

This one I left the doors and lid on by accident and you can see where it started having issues. Withing a few seconds of venting the machine it corrected nicely as you can see in the rest of the print.
Image
Image

Re: First 3d printer. First Prints.

Posted: Thu Feb 01, 2018 2:49 am
by Vicky@Raise3D
Really a nice beginning of 3D printing!
Looking forward to more results of using 3D printing in life.

Re: First 3d printer. First Prints.

Posted: Thu Feb 01, 2018 2:50 am
by Timber Haint
A new one I did tonight...

Hatchbox PLA - (3 shells, 20% infill, no raft)

Image

Image

Image