Show off your prints, mods, etc.
5 posts • Page 1 of 1
3DXTech CarbonX ABS Benchy print with a quick 5 min Acetone vapor treatment! Came out great.. can't wait to make some functional / aesthetically pleasing automotive components. Best of all, this was printed with default ABS settings... simple.
Wow. Which nozzle are you using?
Vice Chief wrote:Wow. Which nozzle are you using?
0.4mm nozzle for this particular print. But am starting to use a 0.8mm quite a bit now as well
Not sure the 0.4mm one you used is copper one or harden type one. We will more recommend you to print Carbon Fiber with harden type one, or filament may abrade the copper nozzle very soon.
Who is online
Users browsing this forum: No registered users and 7 guests