Show off your prints, mods, etc.
1 post • Page 1 of 1
Started printing with poly pc plus. Here are some samples. Two different size filament holders (thanks to whomever designed them!) and a bite plate for my CT scanner. I scanned an existing bite plate and converted the dicom to stl and reprinted it. I am also using polysupport and have had good results with it with the red raise3d pla, but when I print polypc plus and polysupport I get oozing out of the extruder that isn't being used and this messes up the print, doesn't happen with the pla. Any setting I should be looking at? I have yet to install my V2 upgrade. I also have a role of Taulman 680 nylon, does anyone have any suggested settings with that? I had a first good print but now not so good.
Who is online
Users browsing this forum: No registered users and 5 guests