Page 1 of 1

Raise3D did it!

Posted: Wed May 17, 2017 4:15 pm
by ABH
Don't know if this is a serious challenge or not, but I think it shows that Raise3D printers are among the best in printing precision.
No other FDM printer (besides my N1) have reported a successful print of this spinner:
https://www.youtube.com/watch?v=TYuLVN3YHw8

One guy reported success on a Stratasys Objet, but other FDM printers only managed to do the 0.20, 0.15 or 0.10 mm clearance, even Ultimakers.
My N1 printed the part perfectly in first shot. The most challenging 0.05 wheel came loose after a little wrenching and now moves freely without any noticeable play:
https://www.youtube.com/watch?v=b0eNlVuq5BM

Just for fun :-)

Re: Raise3D did it!

Posted: Thu May 18, 2017 6:32 am
by Vicky@Raise3D
Thanks for your sharing.

Re: Raise3D did it!

Posted: Thu May 18, 2017 4:38 pm
by walshlg
cool!

Re: Raise3D did it!

Posted: Mon May 29, 2017 4:17 am
by Mecha_Monster
ABH wrote:Don't know if this is a serious challenge or not, but I think it shows that Raise3D printers are among the best in printing precision.
No other FDM printer (besides my N1) have reported a successful print of this spinner:
https://www.youtube.com/watch?v=TYuLVN3YHw8

One guy reported success on a Stratasys Objet, but other FDM printers only managed to do the 0.20, 0.15 or 0.10 mm clearance, even Ultimakers.
My N1 printed the part perfectly in first shot. The most challenging 0.05 wheel came loose after a little wrenching and now moves freely without any noticeable play:
https://www.youtube.com/watch?v=b0eNlVuq5BM

Just for fun :-)



Amazing!

Angus just did a follow-up video and included you, very impressive. I have to say, I am also very satisfied with the accuracy of this printer

https://www.youtube.com/watch?v=kh7y_CARmmY

Re: Raise3D did it!

Posted: Mon May 29, 2017 7:41 am
by lami3d
yeah, i've just saw it too in angu's video
congrats!