I started using PETG that I buy from Raise store. I do not think I will be printing with anything else. This stuff is fantastic. The G in PETG is glycol it makes this material more malleable thanPLA or polycarbonate or even straight PET for that matter. This is a simple print of an adapter for a shop vac hose for a super on a bee hive. My wife keeps bees and she is constantly asked to get stray swarms from peoples houses.
My settings are .4mm nozzle, .2mm layer height, 50% infill, 3 shells, extruder temp 265c, bed temp 80c, printed using N2+ dual head. my travel speeds are somewhat low 50mm and my first layer is printed at 15mm/s, my flow rate @100%.
I am really grooving on this PETG material from Raise though.
Show off your prints, mods, etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests