Here's the B part of the replacement Electronics Box Cover from Thingiverse with everything dialed in for PETG.
It's prints like this that make a lot of the arguing and tweaking and screwdriver/knob-twisting worth it, especially when the print turns out like this on the first try. I'm really quite pleased with the layers and almost complete lack of stringing/threads on the print.
MadeSolid PETG(Grey)
245C extruder temp, loaded from a PrintDry that was also running.
80C Build Plate temp w/ glue stick on the surface.
30/mm sec shells and 40mm/sec for everything else.
Electronics Box Vent: First Try
Who is online
Users browsing this forum: No registered users and 1 guest