N2 with bondtech heat issue

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
stuflo
Posts: 6
Joined: Thu Oct 19, 2017 7:10 pm

N2 with bondtech heat issue

Postby stuflo » Fri Jul 13, 2018 5:50 pm

I don't know if this is relevant, but i got around to finishing the bondtech upgrade on my second install (it is an earlier model with the black motors and i got it second hand).
Set the v to 0.5 on the stepper and set it up to print and after about 10mins thought i'd check the motor temp and nearly burnt my hand on it then 10 minutes later it had a filament jam.
Its been set up exactly the same as my other printer which the motor is warm to touch but prints 20hr+ prints every time no problem.

So i set the new printer up at v 0.4 and its still hotter than the other printer but its now running .

Dont know if this is something to do with the bondtech stepper motors that are different to the first kit i bought about 8 months ago or another issue that i've got, or if its something similar to what people are seeing with the new N2PRO's.

Return to “Hardware”

Who is online

Users browsing this forum: Alex M. and 6 guests