Pro2 Plus Extruder Fan Question

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Beau
Posts: 3
Joined: Sun May 06, 2018 4:09 am

Pro2 Plus Extruder Fan Question

Postby Beau » Wed May 30, 2018 10:39 pm

Should the left fan run only when the right extruder is active and the right fan run only when the left extruder is active? It seems backwards to me, but I am new at this.

User avatar
Vicky@Raise3D
Posts: 4141
Joined: Fri Mar 25, 2016 3:54 am

Re: Pro2 Plus Extruder Fan Question

Postby Vicky@Raise3D » Thu May 31, 2018 12:56 am

Which versions of RaiseTouch and Motion Board firmwares are currently on your printer? Have you updated them to the latest 0.9.9 and 0-0-31 on our website?

Beau
Posts: 3
Joined: Sun May 06, 2018 4:09 am

Re: Pro2 Plus Extruder Fan Question

Postby Beau » Thu May 31, 2018 10:34 pm

Thank you Vicky! That fixed the issue. I was running the 0-0-18 firmware (and a bit older Touch firmware also). I updated both and now all fans are running beautifully and it seems to be making quite the difference on my print (just started, but the layers already look better). Thanks again.


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest