need help with Vref settings for bondtech extruder
In the manual:
1. if you have black motors...bla bla ...I switched DONE
2. Both stepper drivers need the Vref to 0.5V NOT
3. cables DONE
4. E steps DONE
2. 0.5 V for both mottors
I have a problem with one of them E0 - -22,5 V , I tried to decrease (counter clockwise ) not result inrease up to -23.8 V
How to gain 0.5 V for second motor???
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
3 posts • Page 1 of 1
Last edited by tulipua on Mon May 07, 2018 10:49 pm, edited 1 time in total.
Who is online
Users browsing this forum: No registered users and 4 guests