Planning to swap the original bed with a custom heated bed due to massive flatness deviations and thus failing large prints...
Can anyone tell me what the marked components (if possible + datasheet) in the pictures are and how much W the original heatbed needs? If nothing was changed by R3D it should be around 288-300 W. -> Post
Also, why are there three power connectors for + and - on the bed, when they all go to the same heating wire?
Thanks for the help!
Component 1: 100k 0603 SMD Vishay NTCS0603E3104FXT (4.7k pullup) -> Datasheet
Component 2: 10k Ohms Resistor
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests