Hi there,
I recently bought 2 panucatts stepper motor drivers to replace my X and Y Drivers and I'm not sure if i set the micro stepping switches right, Ive read that they need to be set at 1/16th. Also i seem to have reverse movements when i tried to move my extruder to the home position. if anyone could help me out with this i would greatly appreciate it!
Changing Stepper Motor Drivers
- Vicky@Raise3D
- Posts: 4825
- Joined: Fri Mar 25, 2016 3:54 am
Re: Changing Stepper Motor Drivers
Hope the following link can provide some help to you.
viewtopic.php?f=4&t=634&hilit=panucatt
viewtopic.php?f=4&t=634&hilit=panucatt
-
- Posts: 12
- Joined: Tue Dec 12, 2017 6:11 am
Re: Changing Stepper Motor Drivers
Hey Vicky are the Micro stepping switches set default in the on or off position?
- Vicky@Raise3D
- Posts: 4825
- Joined: Fri Mar 25, 2016 3:54 am
Re: Changing Stepper Motor Drivers
Should be like this.
E1 E0 Z at ON position. X Y at OFF position by default.
E1 E0 Z at ON position. X Y at OFF position by default.
Who is online
Users browsing this forum: No registered users and 5 guests