I have had the same issue twice now where the filament was completely cut by the feed gear during printing, I can't tell if it is a clog or something else (this filament does seem to burn very easily) but I have tried several different temperature settings and I can't find anything that works.
Edit: I am currently cleaning burnt material out of the nozzle, so it probably was related to a clog, but I had the nozzle set to 0 degrees whenever it wasn't printing, so I can't think of any other solutions to the issue...
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests