I suspect it just needs to be adjusted, but what are some other possible causes? additionally it had formed a ring around the feed gear itself but I cleared that before I noticed that it had actually cut the filament completely so I don't have a picture.
Edit: I just took off the cover and noticed that it actually crushed the filament below the gear
Edit 2: the filament is Hydrofill by Airwolf 3d this is my first time printing with it, it seems to be pretty fragile (it is also supposed to be a water soluble support material compatible with ABS)
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests