I am new to 3d printing, the N1 is my first printer, from a single extruder. After many adjustments made with the help of the issues already published, I succeeded in printing the calibration cube correctly. Then I tried to print a model of a 1: 500 scale building, but again the layers ran.
I read about the alignment of the printer and downloaded the clips to hold the belts, I will try to align the printer according to the procedure that has kindly shared Jetguy. I attach the photos.
By the way, I tried to print two clips together, but the layers ran the same.
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
2 posts • Page 1 of 1
Thank you for posting. We have seen this posted to the ticketing system as well. We are responding from there.
Who is online
Users browsing this forum: No registered users and 6 guests