Page 1 of 1

N2 power failure

Posted: Wed Sep 13, 2017 12:23 am
by hhilmarsson
I've been running my N2 for almost a year now and suddenly it just died. I tried couple of times to turn it on again and it started but died again. What I figured out was that it was probably bad connection. I turned it on the side and looked at the power inlet and the power supply. The problem was bad or loose connectors at the power inlet. I had to use pliers to squeeze the connectors together to make solid contact. Please be aware of that and make sure you have quality connectors.
20170911_170416.jpg

/H

Re: N2 power failure

Posted: Wed Sep 13, 2017 2:24 pm
by Brandon
Noted. I will pass this along. Anyone viewing this thread please note. Unplug the power before attempting to put any tool on the terminals of the power inlet of the printer !!!