lrosasco wrote:Any information about the new detection system?
Where does it mount?
Does it detect a clogged nozzle like originally intended in this thread, or does it just do run out?
After it pauses on a empty spool, what are the steps? Is it simple as unload command, load a new spool, purge and continue?
I'm assuming there is going to be some software updates required as well.
It will be located near to guide tube.
It only detects filament run-out.
After it detects no filament coming, it will send a signal to motion board. Then pause the print. The same as you shooting the pause button on screen. The print head will move to front left corner and you can carry out loading and unloading.
Yes, we will release firmware later.