my new Problem is that the printer freezes after printing and displaying the finished screen.
Reset helps, but could not be the solution.
Further is the vent making very much noise, after 4 month of printing (the printer is bought in June this Year and new).
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
3 posts • Page 1 of 1
you need to do a hard reset. there are old posts on the forum for that using that edge connector unless you have one of the newer models with a reset button. using a wire with at-least 1 female socket then short the 6th pin down on the left to the first pin down on the right row of pins, this is not immediate it takes about 2 sec of contact. If that doesn't work then submit a help ticket.
Who is online
Users browsing this forum: No registered users and 5 guests