Raise N2+ freezes after printing

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
3Dnoob
Posts: 7
Joined: Fri Jun 30, 2017 7:55 am

Raise N2+ freezes after printing

Postby 3Dnoob » Wed Sep 06, 2017 11:32 am

Hi,

my new Problem is that the printer freezes after printing and displaying the finished screen.

Reset helps, but could not be the solution.

Further is the vent making very much noise, after 4 month of printing (the printer is bought in June this Year and new).

Any hints?

Thanks

User avatar
walshlg
Posts: 1340
Joined: Wed Mar 23, 2016 12:01 pm

Re: Raise N2+ freezes after printing

Postby walshlg » Wed Sep 06, 2017 3:30 pm

you need to do a hard reset. there are old posts on the forum for that using that edge connector unless you have one of the newer models with a reset button. using a wire with at-least 1 female socket then short the 6th pin down on the left to the first pin down on the right row of pins, this is not immediate it takes about 2 sec of contact. If that doesn't work then submit a help ticket.

User avatar
Brandon
Posts: 100
Joined: Fri May 05, 2017 1:22 pm

Re: Raise N2+ freezes after printing

Postby Brandon » Wed Sep 06, 2017 4:32 pm

@3Dnoob

Please open a ticket for this issue in our support system.

http://help.raise3d.com/support/tickets/new


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest