Raft + Brim? also +10 brim lines.

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
User avatar
Mecha_Monster
Posts: 126
Joined: Wed May 11, 2016 2:07 am
Location: Mexico
Contact:

Raft + Brim? also +10 brim lines.

Postby Mecha_Monster » Tue Sep 05, 2017 8:57 pm

Hi,

When I set the print to have a raft + brim, the software does as said, but it leaves a small gap between both of about the width of the extruder. How can I eliminate that gap and fuse the brim and the raft?

Also, as request, would it be possible to increase the max number of brim lines?


Thanks!

User avatar
walshlg
Posts: 1274
Joined: Wed Mar 23, 2016 12:01 pm

Re: Raft + Brim? also +10 brim lines.

Postby walshlg » Wed Sep 06, 2017 3:51 pm

I have seen that as well, it seems to print a skirt rather than brim when printing with a raft.

User avatar
Brandon
Posts: 65
Joined: Fri May 05, 2017 1:22 pm

Re: Raft + Brim? also +10 brim lines.

Postby Brandon » Thu Sep 07, 2017 2:46 am

I will look into this and get back with you.

User avatar
Vicky@Raise3D
Posts: 2248
Joined: Fri Mar 25, 2016 3:54 am

Re: Raft + Brim? also +10 brim lines.

Postby Vicky@Raise3D » Thu Sep 07, 2017 1:44 pm

The gap problem should have been already fixed in 2.6.0. Please take a try.

For the max number, how big do you need?

User avatar
Mecha_Monster
Posts: 126
Joined: Wed May 11, 2016 2:07 am
Location: Mexico
Contact:

Re: Raft + Brim? also +10 brim lines.

Postby Mecha_Monster » Thu Sep 07, 2017 5:06 pm

Hi Vicky, thank you for your response. I will give it a try.

<10 layers works perfect for most materials, even with PC. Nevertheless, ABS stills struggles a little bit. 5 extra lines will help a lot.


Thank you!

User avatar
Vicky@Raise3D
Posts: 2248
Joined: Fri Mar 25, 2016 3:54 am

Re: Raft + Brim? also +10 brim lines.

Postby Vicky@Raise3D » Thu Sep 07, 2017 7:34 pm

Notes taken.


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 5 guests