This mod is not a big thing: I simply replaced the original Push-Fit Connector by one from E3D:
An advantage of these type is, that you don't need to insert an additional tube. At least in my case it was also not possible to fully slide the PTFE tube through the coupling. So changing a spool of filament has always been a bit of a fumbling.
With the E3D couplings it is very easy to slide the PTFE tube in or feed it through.
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests