E3D Push-Fit Connector

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Posts: 239
Joined: Mon Mar 21, 2016 2:55 pm

E3D Push-Fit Connector

Postby socke » Tue Sep 05, 2017 7:01 pm

This mod is not a big thing: I simply replaced the original Push-Fit Connector by one from E3D:


An advantage of these type is, that you don't need to insert an additional tube. At least in my case it was also not possible to fully slide the PTFE tube through the coupling. So changing a spool of filament has always been a bit of a fumbling.
With the E3D couplings it is very easy to slide the PTFE tube in or feed it through.

User avatar
Posts: 100
Joined: Fri May 05, 2017 1:22 pm

Re: E3D Push-Fit Connector

Postby Brandon » Thu Sep 07, 2017 2:21 am

Good Tip. Thank you for posting it.

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 5 guests